Config Pos Info Command; Figure 33 Config Pos Info Command Sample Output; Table 35 Config Pos Stg Command Parameters And Variables - Nortel Passport 8683POS Using Manual

98 Chapter 6 Command line interface
Table 35
command.

Table 35 config pos stg command parameters and variables

Parameters and variables
faststart <enable | disable>
info
pathcost <intval>
priority <intval>
stg <enable | disable>

config pos info command

The config pos info command shows the current state of the port.
Figure 33

Figure 33 config pos info command sample output

Passport-8610:5/config# pos 10/5 info
Port 10/5 :
Passport-8610:5/config#
209564-A
describes the parameters and variables for the config pos stg
Description
Enables or disables the fast start flag.
Shows the last saved port settings and the next-level CLI commands.
Note that this does not show the current settings, but the last saved
settings.
Sets the contribution of this port to the path cost.
Sets the priority of this port.
Enables or disables spanning tree protocol.
shows a sample of the output from the
unknown-mac-discard : disable
default-vlan-id : 1
perform-tagging : disable
tagged-frames-discard : disable
untagged-frames-discard : disable
linktrap : enable
port-type : OC3-MMF
config pos info
lock : false
name :
state : up
command.