Table of Contents
Advertisement
3.2 Start-up
The protected equipment connected to the UPS can be energized, whether AC input power is available
or not.
Prior to initial start-up, check the UPS voltage settings. If the protected equipment voltage is other
than 230 V / 50 Hz, the UPS settings must be modified using the "UPS Driver" software
(see section 3.5).
If LEDs
3.3 Bargraph indications
LEDs
14
8
24
21 22
23
,
and
do not go ON or if LEDs
to
17
provide three different indications.
14
15
16
17
18
1. Set the battery circuit breaker(s)
2. Press the ON / OFF button
All connected equipment is energized. The buzzer sounds.
21
22
LEDs
,
and
23
go ON.
14 15
,
,
16
or
17
flash, there is a fault (see section 4.1).
1. Remaining backup time in percent.
2. Percent load drawn by the protected equipment,
when button
is pressed.
18
3. Operating faults (flashing LED and beeps):
14
Overload.
UPS fault.
15
16
Battery fault.
17
Excessive ambient temperature.
3. Operation
27
to ON.
8
24
.
- Page 19
5103321100/AA
Hide quick links:
Advertisement
Table of Contents
