Install - MGE UPS Systems Pulsar Extreme 1500 VA Installation And User Manual

Install

This type of connection must be carried out by qualified electrical personnel.
Before carrying out any connections, check that the battery circuit breaker
and that the upstream protection devices (AC distribution system) are open (OFF).
The overall cable diameter and the cross-sectional area
of the three wires depends on the UPS rating.
8
EXtreme 1500 to 2000
EXtreme 2500 to 3000
32
Power and equipment connections:
1. Remove the terminal-block cover
2. Insert the cable supplying the equipment and the power
cable through the cable clamps
3. Connect the three wires of the equipment cable to the output
terminal block
4. Connect the three wires of the power cable to the input
terminal block
5. Refit the terminal_block cover.
6. Tighten the nut on the cable clamp
33
Earthing wires
5
4
2. Installation
cable diameter
(mm)
9 to 12
9 to 12
33
.
5 .
Always connect the earthing wire first.
4
.
8 is OFF
cross-sectional area
of each wire (mm)
1 to 4
1,5 to 4
32 .
33
.
- Page 17
5103321100/AA