Hot Swap - MGE UPS Systems Pulsar Extreme 1500 VA Installation And User Manual

2. Installation

Hot swap

Before carrying out any connections, check that the battery circuit breaker
and that the electrical power cord to the AC-power source is disconnected.
Page 16 -
5103321100/AA
2
8
32
33
5
Earthing wire
1
29
Connection of equipment to outlets
Plug your equipment into the outlets
Connection of equipment to a terminal block:
This type of connection must be carried out by qualified
electrical personnel.
1. Remove the terminal-block cover
2. Insert the cable supplying the equipment through the cable
clamp .
33
3. Connect the three wires to the output terminal block
Always connect the earthing wire first.
4. Remove the terminal-block cover.
5. Tighten the nut on the cable clamp
The overall cable diameter and the cross-sectional area
of the three wires depends on the UPS rating.
cable diameter
(mm)
EXtreme 1500 to 2000
EXtreme 2500 to 3000
Connection to the AC-power source:
1. Connect the electrical power cord
for connection to AC-power source.
2. Connect the other end of the electrical power cord
to an AC-power outlet.
is OFF
8
2 .
32 .
.
33
cross-sectional area
of each wire (mm)
9 to 12 1 to 4
9 to 12 1,5 to 4
29 to the socket
5
.
1