Removing The Library From The Rack - Qualstar RLS-8350 Installation And Operation Manual

5.2.6

Removing the Library from the Rack

THE RLS WEIGHS UP TO 174 LBS (79 KG) ), INCLUDING STORAGE MATRICES
AND TAPE DRIVES AND A MINIMUM OF TWO PEOPLE ARE NEEDED TO LIFT IT.
HANDLING THE RLS ALONE COULD RESULT IN BACK INJURY OR OTHER
ACCIDENTS.
1. Remove power from the RLS by first pressing the power switch off and then
removing the power cord.
2. Disconnect any other cables from the RLS.
3. If the storage matrices have not already been removed from the library, follow
the procedure described in Section 5.7.5 to remove them.
4. For RLS-8560 libraries ONLY follow steps 5 through 12 to remove the storage
matrix assembly blank.
5. The blank is secured to the RLS with two captive screw fasteners, which can be
reached by inserting a hand through the opening created when the left side
storage matrix is removed. This is the preferred and simpler option, however if
the screws cannot be accessed through this opening the face of the user interface
panel assembly can also be removed (step 8).
5-26
DANGER
Installation
511000 Rev. F