Qualstar RLS-8350 Installation And Operation Manual page 34

Before unpacking the unit, check the shipping container for damage, and report all shipping
damage to the carrier before opening the carton.
Refer to Figure 4-1
With the help of an assistant, follow the instructions below.
1. Open the top of the carton.
2. Remove the material (this manual, line cord, rack mounting kit and other
accessories) from inside the foam that is on top of the library.
3. Remove the foam from the top of the library.
4. Using a Phillips screwdriver, remove the drywall screws and fender washers that
attach the shipping carton to the pallet.
5. Lift the shipping carton off from the library.
6. Remove the four thumbscrews that secure the library to the pallet. There is one
thumbscrew on the left and right sides and two thumbscrews at the rear.
7. With the help of an assistant the library may now be removed from the pallet.
The library should be carefully lifted by grasping the hand holds on the front left
and right sides along with the hand hold on its rear.
8. Unload the accessory pack and rack rail pack.
9. Place all shipping materials back into the shipping carton for future use.
Be sure to retain the pallet, carton and all packing materials for possible reshipment. All items are
needed to properly repack the RLS.
Failure to reship an RLS in the original packing materials will most assuredly result in damage to
the RLS and will void of the shipper's insurance and the factory warranty.
4-2
NOTE
NOTE
Unpacking
511000 Rev. F