Qualstar RLS-8350 Installation And Operation Manual page 43

6. Store the front hand holds and their mounting screws in a safe location so they
may be re-used if the library is removed from the rack.
7. With the hand holds removed, slide the library all the way back into the rack
until the flanges on the sides touch the front rack posts.
Figure 5-8 The Library fully inserted into the Rack (RLS-85XX shown)
8. Confirm that the library is housed properly in the rack. The two holes in each of
the flanges should line up with the cage nuts that were installed earlier in the
front rack posts.
9. Use a Number 2 Phillips screwdriver to install the two screws (one on each side)
that secure the library to the front rack posts.
10. For RLS-8350 and 85120 libraries follow the procedure described in Section 5.7.5
to reinstall the storage matrices and connect all necessary cables.
11. For RLS-8560 libraries ONLY follow steps 11 through 23 to install the storage
matrix assembly blank.
5-8
Install one screw in each rack post
to secure the library to the rack.
(there are 8 potential locations)
Installation
Flange
511000 Rev. F