Qualstar RLS-8350 Installation And Operation Manual page 45

Figure 5-10 Captive screw shown securing the bottom tab of the Storage Matrix Assembly Blank
15. Reaching into the RLS through the left side storage matrix opening, engage the
two captive screw fasteners and turn them clockwise until they are fully
tightened to hold the blank to the RLS.
16. If the screws can be reached, skip to step 19, otherwise follow the next step to
remove the face of the user interface panel assembly.
17. IF the screws could not be reached through the left side opening, there are four
screws securing the face of the user interface panel assembly to the RLS.
Removing the assembly will allow for easier access to the screws.
18. Using the supplied 3/32 Allen wrench remove the four screws shown in Figure
5-11 that secure the user interface panel assembly. Use caution to avoid
damaging the touch screen while using the wrench.
5-10
Captive screw used to secure the top and bottom tabs.
Installation
Storage Matrix
Assembly Blank
511000 Rev. F