Table of Contents
Advertisement
PDFMAILER.DE
To remove:
1.
Remove the front cover (see page 11).
Move the front cover so that you can pull out the driving motor connector.
2.
Remove the receptacle (See page 27).
3.
Remove the belt.
4.
Removes screw A and remove cord guide B.
5.
Pull out the motor connector from the A-board.
6.
Remove screws C and D.
7. Take out the motor.
To attach:
1.
Set the motor in machine and replace screws C and D.
2.
Snap the motor connector into the a-board.
3. Attach cord guide B using screw A.
4.
Replace the motor belt.
5.
Move the motor mounting bracket E by applying approximately 300 g pressure in
the middle of the belt, it should deflect 7 to 9 mm when set properly.
6.
Tighten screw C and D.
7.
Replace the front cover.
DC MOTOR
30
Hide quick links:
Advertisement
Table of Contents
