Replacing Dc Motor And Motor Belt Tension Adjustment - ELNA 8200 Service Manual

Model 8200

Replacing DC Motor and Motor Belt Tension Adjustment

A
10
B
B
Pressure 200 grams
D
Deflection 5 mm
C
Replacing DC Motor
1. Remove the belt cover. (See page 2)
2. Remove the motor belt.
3. Remove the Motor connector
circuit board "A" (Main board).
A
4. Remove Screw
5. Remove Screws
motor.
6. Attach the motorand tighten Screws)
slightly.
Adjusting motor belt tension
1. Adjust the Belt deflection to about 5.0 mm
pressing the middle of the motor belt with your
finger with approximately 200 grams
25
from the printed
10
.
B (2 pieces) and replace the
B (2 pieces)
D
C by
of pressure.