Replacing Dc Motor; And Adjusting Motor Belt Tension - ELNA eXperience 660 Service Manual

REPLACING DC MOTOR AND ADJUSTING
TO REMOVE:
1. Remove the belt cover (see page 8).
2. Disconnect the motor connector.
Remove the two setscrews, then remove the dc motor and belt.
TO ATTACH:
3. Set the motor in machine and replace screws. Replace the motor belt.
4. When applying approximately 300 grams pressure in the middle of the belt, it should deflect 7 to 9
mm when set properly.
5. Tighten the setscrews.
6. Attach the belt cover.
Motor connector
MOTOR BELT TENSION
Pressure 300g
Belt deflection 7-9 mm
DC motor
Setscrews
(2)
28
MODEL:eXperience 660
Belt