Replacing DC Motor and Motor Belt Tension Adjustment
2
4
1
3
5
6
Replacing DC Motor
To remove:
1 Remove the belt cover. (See page 2)
2 Remove the motor belt.
3 Remove the Motor connector
circuit board A.
4 Remove Screws (A)
motor.
To attach:
5 Tighten Screws (A)
attach the motor.
6 Adjust the motor belt tension and tighten screws (A)
(2 pieces) firmly.
3
Adjusting motor belt tension
1. Tighten screws (B)
2. Adjust the Belt deflection to about 5.0 mm
pressing the middle of the motor belt with your
finger with approximately 200 grams
1
Motor belt
2
Motor connector
3
Screws (A)
4
Screws (B)
5
Pressure 200 grams
6
Deflection 5 mm
24
1
from the printed
3
(2 pieces) and replace the
(2 pieces) temporarily and
3
(2 pieces) temporarily.
4
of pressure.
5
6
by