Pci Configuration Setup; Load Bios Defaults - DFI G586IPB User Manual

Hide thumbs Also See for G586IPB:

Table of Contents

Choosing " Enabled" in the Power Management option will allow you to

set Doze Mode, Standby Mode and Suspend Mode. Choose " Disabled"

if you do not want your system to enter the power saving mode.

PCI Configuration Setup

Use the arrow keys to highlight " PCI Configuration Setup" and press

<Enter>; a screen similar to the one below will appear.

The G586IPB/E system board supports four PCI slots. Each slot may be

assigned INT A, B, C, D if the card installed in the slot requires an

interrupt. Each INT may then be assigned an IRQ value. This is done

automatically if the " PnP BIOS Auto-Config" option is enabled.

The " Load BIOS Defaults" option loads the troubleshooting default val-

ues permanently stored in the ROM chips. These settings are non-opti-

mal and turn off all high performance features. You should use these

values only if you have hardware problems. Highlight this option in the

main screen and press <Enter>. The message below will appear.

Load Setup Defaults (Y/N) ? N

If you want to proceed, press <Y> and the default settings will be

loaded.

Table of Contents

G586ipe