DFI G586IPB User Manual page 11

2. Remove the system unit cover. Refer to the manufacturer' s instruc-
tions if necessary.
3. Remove expansion cards seated in any of the expansion slots and
detach all connectors from the old system board.
4. Loosen the screws holding the original system board and remove
the board from the system. Save the screws.
5. Remove the G586IPB/E from its original packing box. Be careful to
avoid touching all connectors and pins on the board. Please refer to
the handling instructions on pages 9-10 for proper handling tech-
niques.
6. Insert the SIMMs into the SIMM banks on the G586IPB/E. The
quantity and location of the SIMMs depends on the memory con-
figuration and type of modules you intend to use.
7. Insert the cache module, if any, into the cache module slot on the
G586IPB/E. Refer to the Cache Memory section on page 14 for
upgrading your cache memory.
8. Install the CPU. Be sure pin 1 of the CPU is aligned with pin 1 of
the socket.
9. Set the corresponding jumpers.
10. Install the prepared G586IPB/E system board into the case and re-
place the screws.
11.
Reinstall all cards and connectors and replace the system unit
cover. Reconnect all power cords and cables.
11