Table of Contents
Advertisement
If you experience difficulty with the G586IPB/E system board, please
refer to the checklist below. If you still cannot identify the problem,
please contact your dealer.
1. Check the jumper settings to ensure that the jumpers are properly
set. If in doubt, refer to the " Hardware Installation" section.
2. Verify that all SIMMs are seated securely into the bank sockets.
3. Make sure the SIMMs are in the correct locations.
4. Check that all populated memory banks are filled with correctly
sized SIMMs.
5. If your board fails to function, place the board on a flat surface and
seat all socketed components (gently press each component into
the socket).
6. If you made changes to the BIOS settings, re-enter setup and
load the BIOS defaults.
Troubleshooting Checklist
Chapter 4
49
Advertisement
Table of Contents
