Oki C3530nMFP Maintenance Manual page 168

Display Cause
Service call System memory
190: Error overflow
Service call PU Firmware
200: Error Download Error
202: Error
Service cal Custom Media
l209: Type table
Down Load download failure
Error
Service call CU program
203: Error trouble (203~214
204: Error are not generated
207: Error in usual
208: Error operation)
213: Error
214: Error
F0C: Error
FFE: Error
FFF: Error
Service call RFID Reader not
230: Error Installed
Service call RFID Reader I/F
231: Error Error
Service call Engine Program.
240: Error Memory Error
Service call Short circuit
905: Error error of the
906: Error Frame thermistor
(thermistor
defect) is
detected
Service call High
907: Error temperature
error of the frame
thermistor (over
150)is detected
43605601TH Rev. 1
Table 7-1-2 service call error list (4/6)
Details of error
Does the error recur?
Error occurs when the PU firmware
is rewritten
Failed in downloarding
Custom Media Type Table
Incorrect processing is performed
by the CU program.
Does the error recur?
RFID Reader Device error.
Does the error recur?
An interface error was detected
with the RFID reader device.
01: communication error between
the RFID reader and the engine
PCB.
02:the transcever circuit error of
the RFID reader.
03:communication error between
the RFID reader and the Tag chip.
04:the RFID Tag detection error
(more than 4chips).
240: Flash Memory
Hardware Error
Does the error recur?
Does the error recur?
Oki Data CONFIDENTIAL
Method
Turn on the power supply again.
Yes Install an additional RAM DIMM.
After the power supply is turned
on again, try to download again.
(Because this processing is
not performed during usual
operation, it does not occur.)
After the power supply is turned
on again, try to download again.
(Because this processing is
not performed during usual
operation, it does not occur.)
Turn on the power supply again.
Replace M32 board.
Yes Check the connenction of the
LUM board (RFIS reader/writer
board).
Yes Replace the LUM board (RFID
reader/writer board).
Replace the M32 board.
01: Same as Error 230.
02: Replace the LUM board
(RFID reader/writer board).
03: Check the connection of the
antenna cable.
04: Check if the number of RFID
Tags is correct.
If the error occurs again after
returning on the power supply,
replace the board of the unit.
Yes Check the cable connection
between the ZAK board and M32
board and turn on the power
again.
Replace the fuser unit.
Replace the M32 board.
Yes Check the cable connection
between the ZAK board and M32
board and turn on the power
again.Replace the fuser unit.
Replace the M32 board.
168 /