Oki C3530nMFP Maintenance Manual page 112

• If you want to specify the PU serial number, please add a "0" (a normal-width zero)
then input the 11-digit number. (Please notice that when read out, the number will be 10
digits.)
As shown in the following image, on the menu of [PU serial number setting], eliminate
the 2-digit revision number then add a normal-width zero to the 10-digit number and
input it.
• PU serial number will be output to the Printer Serial Number column in the header of
Status Page. For this reason, check of PU serial number is performed by printing
Status Page.
• After the configuration in the UK factory, when facing OEL, the PU serial number is taken
as Lot Number and shown in the Lot Number: column of the last line which is in the
header of the Status Page.
(1-2) Set the CU serial number
SAP serial number can be applied to the device. The SAP serial number is displayed
in the highest rung of the serial number label. It is a 12-digit number including
production place (2 digits), production year (2 digits), sequence number (6 digits)
and revision number (2 digits).
• CU serial number is given an original number which is within 12 digits in the UK factory.
• Please notice that if you set the CU serial number, the menu setting in CU will be reset
(back to the default setting).
43605601TH Rev. 1
Ser.NO. 4AEL4011702K
Lot.NO. AE47027880 A0
Made in Thailand
Configured in UK
Add one-byte 0 to the top of 10-digit figure of Lot.NO.
Set "0AE47027880" in the setting screen.
Figure of Serial No. label image (labeled in UK Factory)
Input 12 digits for Ser. NO. Input "4AEL4011702K".
Ser.NO. 4AEL4011702K
Lot.NO. AE47027880 A0
Made in Thailand
Configured in UK
Figure of Serial No. label image (labeled in UK Factory)
Oki Data CONFIDENTIAL
Revision
112 /