Mac Address Clone - UTT HiPER 840G Advanced Configuration Manual

UTT Technologies

5.1.3 MAC Address Clone

Some ISPs register the MAC address of your network device (usually a computer) when
your account is first opened, and they will only accept traffic from that MAC address. With
MAC address clone feature, you may assign the registered MAC address to the Gigabit
Router's external interface if you don't want to re-register the MAC address with your ISP.
To configure MAC address clone, go to the Network > WAN page, and then select the
MAC Address Clone tab to go to the setup page shown in Figure 5-10 MAC Address
CloneFigure 5-10. In this page, you can change the MAC address of each external
interface (WAN1 or APClient interface) as required.
WAN1 MAC Address: It specifies the MAC address of the Gigabit Router's WAN1
interface.
APClient MAC Address: It specifies the MAC address of the Gigabit Router's
APClient interface.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
http://www.uttglobal.com
Figure 5-10 MAC Address Clone
Chapter 5 Network
Page
4040