How To Reset The Gigabit Router To Factory Default Settings - UTT HiPER 840G Advanced Configuration Manual

UTT Technologies
4. How to reset the Gigabit Router to factory default
settings?
Note
The reset operation will clear all the custom settings on the Gigabit Router, so do it
with caution.
The following describes how to reset the Gigabit Router to factory default settings. There
are two cases depending on whether you remember the administrator password or not.
Case One: Remember the administrator password
●
When you remember the administrator password, you can reset the Gigabit Router to
factory default settings via the Web UI. The operation is as follows: Go to the
Administration > Configuration page, and then click the Reset button in the Reset to
Factory Defaults configuration field, lastly manually restart the Gigabit Router.
Case Two: Forget the administrator password
●
If you forget the administrator password, you cannot login to the Gigabit Router's Web UI.
However, you can reset the Gigabit Router to factory default settings via the RESET
button, which is located on the rear panel of the Gigabit Router. The operation is as
follows: While the Gigabit Router is powered on, use a pin or paper clip to press and hold
the RESET button for more than 5 seconds, and then release the button. After that, the
Gigabit Router
http://www.uttglobal.com
will restart with factory
Appendix B FAQ
default settings.
Page
15815815