UTT HiPER 840G Advanced Configuration Manual page 174

UTT Technologies
Go to the VPN > IPSec > IPSec Settings page, make the following settings (leave the
default values for the other parameters), and then click the Save button.
Key Mode
Connection Type
Gateway IP/Domain Name
(Remote)
Subnet IP (Remote)
Subnet Mask (Remote)
Bind to (Local)
Subnet IP (Local)
Subnet Mask (Local)
ID Type (Local)
ID Value (Local)
Preshared Key
P2 Encrypt/Auth Algorithms 1 esp-aes192-sha
Advanced Options
Exchange Mode
3. Viewing the IPSec tunnel status
After you have configured IPSec parameters on both UTT VPN gateways, the IPSec
tunnel establishment can be triggered manually or by traffic.
On the UTT VPN gateway, you can go to the VPN > IPSec > IPSec List page to view the
configuration of the IPSec tunnel, including the Remote Gateway, Remote Subnet IP,
Bind to and Local Subnet IP, see Figure 11-31 Responder's IPSec List – UTT VPN
Gateway to UTT VPN Gateway (Answer-Only)andFigure 11-32 Initiator's IPSec List –
UTT VPN Gateway to UTT VPN Gateway (Answer-Only). After the IPSec tunnel has
been established, you can see that the SA Status displays Established.
1) Viewing the UTT VPN gateway at the head office
The following figure shows the configuration and status of the IPSec tunnel on the UTT
VPN gateway
http://www.uttglobal.com
AutoKey (IKE)
Originate-Only
200.200.202.123
192.168.123.1
255.255.255.0
WAN1
192.168.16.1
255.255.255.0
Email Address
hiper@utt.com.cn
testing
Aggressive
with a static IP address at
Chapter 10 VPN
the head office.
Page
20720720