System Time - UTT HiPER 840G Advanced Configuration Manual

UTT Technologies

10.2 System Time

This section describes the Administration > Time page, see Figure 10-3.
To ensure that the time-related features (e.g., DDNS, Schedule, Access Control, etc.)
work well, you should synchronize the system clock.
You can manually configure the system time or enable SNTP (Synchronize with SNTP
Server) to automatically synchronize the system time from a designated SNTP server on
the Internet. It is suggested that you choose SNTP to automatically synchronize time in
most cases.
Current System Time: It displays the Gigabit Router's current date (YYYY-MM-DD)
and time (HH:MM:SS).
Time Zone: It specifies the time zone for your local time. To ensure that SNTP
operates properly, you must select the correct time zone.
Set Time Manually: If you want to set the date (YYYY-MM-DD) and time (HH:MM:SS)
for the Gigabit Router manually, select this radio button.
Synchronize with SNTP Server: If you want the Gigabit Router to automatically
synchronize the system clock from a designated SNTP server on the Internet, select
this
http://www.uttglobal.com
Figure 10-3 System Time Settings
radio
Chapter 11 System Administration
Page
21221221
button.