Pppoe Server Global Settings - UTT HiPER 840G Advanced Configuration Manual

UTT Technologies

6.4.2 PPPoE Server Global Settings

Enable PPPoE Server: It allows you to enable or disable PPPoE server. If you want
to enable PPPoE server on the Gigabit Router, please select this check box.
Start IP Address: It specifies the starting IP address that is assigned by the PPPoE
server.
Primary DNS Server: It specifies the IP address of the primary DNS server that is
available to a PPPoE client.
Secondary DNS Server: It specifies the IP address of the secondary DNS server
that is available to a PPPoE client.
PPP Authentication: It specifies the PPP authentication mode by which the PPPoE
server authenticates a PPPoE client. The available options are PAP, CHAP and
AUTO. In most cases, please leave the default value of AUTO, which means that the
Gigabit Router will automatically choose PAP or CHAP to authenticate the PPPoE
client.
Maximum Sessions: It specifies the maximum number of PPPoE sessions that can
be created on the Gigabit Router.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
http://www.uttglobal.com
Figure 6-22 PPPoE Server Global Settings
Chapter 7 Advanced
Page 93