UTT HiPER 840G Advanced Configuration Manual page 161

UTT Technologies
ID Type (Local): It specifies the type of local ID. The available options are Domain
Name, Email Address, IP Address and Other. In this connection type, it is a
required parameter. You must select one type and then specify ID Value (Local) to
allow the remote IPSec device to authenticate the local UTT VPN gateway.
ID Value (Local): It specifies the identity of the local UTT VPN gateway. In this
connection type, it is a required parameter. Please enter an ID value according to the
selected ID Type (Local).
3) Answer-Only (Static-to-Dynamic IPSec VPN)
If the local UTT VPN gateway has a static IP address, and the remote endpoint
(another UTT VPN gateway or compatible VPN appliance) has a dynamically assigned IP
address, you can choose Answer-Only as the connection type (see Figure 11-24 IPSec
Settings (AutoKey (IKE) – Answer-Only)). In this case, the local UTT VPN gateway can
only act as a responder, and both IPSec endpoints should use aggressive mode for phase
1 IKE negotiation.
Figure 11-24 IPSec Settings (AutoKey (IKE) – Answer-Only)
The parameters Gateway IP/Domain Name (Remote), Subnet IP (Remote), Subnet
http://www.uttglobal.com
Chapter 10 VPN
Page
19419419