TP-Link TL-WR810N User Manual page 97

To add static routing entries, follow the steps below.
Click Add New... shown in Figure 4-72, you will see the following screen Figure 4-73.
1.
2. Enter the following data.
 Destination Network - The Destination IP Address is the address of the network or host
that you want to assign to a static route.
Subnet Mask - The Subnet Mask determines which portion of an IP Address is the

network portion, and which portion is the host portion.
 Default Gateway - This is the IP Address of the gateway device that allows for contact
between the Router and the network or host.
3. Select Enabled or Disabled for this entry on the Status drop-down list.
Click the Save button to make the entry take effect.
4.
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.
Click the Disable All button to disable all the entries.
Click the Delete All button to delete all the entries.
Click the Previous button to view the information in the previous screen, click the Next
button to view the information in the next screen.
TL-WR810N 300Mbps Wi-Fi Pocket Router/AP/TV Adapter/Repeater
Figure 4-72 Static Routing
Figure 4-73 Add or Modify a Static Route Entry
- 82 -