Dhcp Client List - TP-Link TL-WR810N User Manual

Start IP Address - Specify an IP address for the DHCP Server to start with when assigning

IP addresses. 192.168.0.100 is the default start address.
End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP

addresses. 192.168.0.199 is the default end address.
Address Lease Time - The Address Lease Time is the amount of time a network user will

be allowed connection to the Router with their current dynamic IP Address. Enter the
amount of time in minutes and the user will be "leased" this dynamic IP Address. After the
time is up, the user will be automatically assigned a new dynamic IP address. The range of
the time is 1 ~ 2880 minutes. The default value is 120 minutes.
Default Gateway (Optional) - It is suggested to input the IP address of the LAN port of the

Router. The default value is 192.168.0.254.
Default Domain (Optional) - Input the domain name of your network.

Primary DNS - (Optional) Input the DNS IP address provided by your ISP or consult your

ISP.
Secondary DNS (Optional) - Input the IP address of another DNS server if your ISP

provides two DNS servers.

Note:
1. To use the DHCP server function of the Router, you must configure all computers on the LAN
as "Obtain an IP Address automatically".
When you choose the Smart IP (DHCP) mode in Network → LAN, the DHCP Server
2.
function will be disabled. You will see the page as below.

5.8.2 DHCP Client List

Choose menu "DHCP → DHCP Clients List", and then you can view the information about the
clients attached to the Router in the screen as shown in Figure 5-21.
TL-WR810N 300Mbps Wi-Fi Pocket Router/AP/TV Adapter/Repeater
Figure 5-20 DHCP Settings
- 117 -