Installing The Middle Driven Shaft Assembly; Installing The Middle Gear Case Cover - Yamaha FJR1300A(D) Service Manual

• Middle drive pinion gear nut "2"
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Tighten the middle drive pinion gear nut to
specification.
Middle drive pinion gear nut
160 Nm (16.0 m·kg, 115 ft·lb)
TIP
• Lubricate the nut threads with engine oil.
• Install the middle drive pinion gear nut with its
large inner diameter side facing inward as
shown in the illustration.
• While holding the middle drive shaft.
b. Bend the lock washer tab along a flat side of
the nut.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS25870
INSTALLING THE MIDDLE DRIVEN SHAFT
ASSEMBLY
1. Install:
• Middle driven shaft assembly
• Middle driven pinion gear shims "1"
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
• Middle driven shaft end cover
▼▼▼ • Middle driven shaft bearing housing bolts
TIP
Finger tighten the middle driven shaft bearing
housing bolts.
2. Tighten:
• Middle driven shaft bearing housing bolts
TIP
Before tightening the bolts:
1. Adjust the middle gear backlash.
Refer to "ADJUSTING THE MIDDLE GEAR
BACKLASH" on page 5-73.
2. Check that the middle gears turns smoothly.
ET3P61025
INSTALLING THE MIDDLE GEAR CASE
COVER
1. Install:
• Middle gear case cover
• Middle gear case cover bolts
TIP
Apply locking agent (LOCTITE®) to the threads
of the bolts "1".
▲▲▲
1
5-72
MIDDLE GEAR
Middle driven shaft bearing hous-
ing bolt
25 Nm (2.5 m·kg, 18 ft·lb)
LOCTITE®
Middle gear case cover bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)