Installing The Front Fork Legs - Yamaha FJR1300A(D) Service Manual

a
15.Install:
• Fork spring
TIP
Install the fork spring so that the end "A" shown
in the illustration is facing up.
A
16.Install (right side):
• Washer "1"
• Spacer "2"
• Nut "3"
• Damper adjusting valve spring "4"
• Damper adjusting valve "5"
• Damper adjusting rod "6"
• Cap bolt "7"
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Install the washer "1" and spacer "2".
b. Install the nut "3" all the way auto the damper
rod assembly and finger tighten it.
c. Install the damper adjusting valve spring "4",
damper adjusting valve "5", and damper ad-
justing rod "6".
d. Install the cap bolt "7" and finger tighten it.
EWA13670
WARNING
Always use a new cap bolt O-ring.
e. Hold the cap bolt and tighten the nut "3" to
specification.
Front fork cap bolt locknut
14 Nm (1.4 m·kg, 10 ft·lb)
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
2
1
▲ ▲▲▲ ▲ ▲▲▲ ▲
17.Install (left side):
• Washers "1"
• Spacer "2"
▼▼▼
18.Install:
• Cap bolt
(to the outer tube)
TIP
Temporarily tighten the cap bolt.
EAS23050

INSTALLING THE FRONT FORK LEGS

The following procedure applies to both of the
front fork legs.
1. Install:
• Front fork leg
Temporarily tighten the upper and lower
bracket pinch bolts.
TIP
Make sure the inner tube is flush with the top of
the upper bracket.
4-92
FRONT FORK
6
3
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
6
5
4
3
▲ ▲▲▲ ▲ ▲▲▲
1
2
1