Installing The Middle Driven Shaft - Yamaha YFM660FR Supplementary Service Manual

MIDDLE GEAR

INSTALLING THE MIDDLE DRIVEN SHAFT

1.Install:
Bearing retainer 1
G
NOTE:
Attach the ring nut wrench 2.
Ring nut wrench:
P/N. YM-38404, 90890-01430
CAUTION:
The middle driven shaft bearing retainer
has left-handed threads. To tighten the
retainer, turn it counterclockwise.
2.Install:
Bearing retainer 1
G
*****************************************************
Installation steps:
Place a rag 2 in the vise.
G
G
Secure the bearing housing edge in the vise.
Attach the bearing retainer wrench 3.
G
Bearing retainer wrench:
P/N. YM-04128, 90890-04128
G
Tighten the bearing retainer.
CAUTION:
The middle driven shaft bearing retainer
has left-handed threads. To tighten the
retainer, turn it counterclockwise.
Bearing retainer:
110 Nm (11.0 m • kg, 80 ft • lb)
*****************************************************
3.Install:
Shims 1
G
Bearing housing
G
NOTE:
Install the shims so that the tabs are positioned
as shown in the illustration.
– 28 –
ENG
LT
80 Nm (8.0 m • kg, 58 ft • lb)
LT