Yamaha FJR1300A(D) Service Manual page 486

EAS30610
DIAGNOSTIC MODE
Setting the diagnostic mode
1. Turn the main switch to "OFF".
2. Disconnect the wire harness coupler from the fuel pump.
3. Simultaneously press and hold the "TCS" button "1" and "RESET" button "2", turn the main switch
to "ON", and continue to press the buttons for 8 seconds or more.
1
2
TIP
All displays on the multi-function meter right display disappear and "DIAG" appears.
4. Simultaneously press the "TCS" button and "RESET" button for 2 seconds or more to set the diag-
nostic mode.
TIP
Diagnostic code number "01" appears on the multi-function meter right display.
5. Select the diagnostic code number corresponding to the fault code number by pressing the "TCS"
button and "RESET" button.
TIP
• To decrease the selected diagnostic code number, press the "RESET" button. Press the "RESET"
button for 1 second or more to automatically decrease the diagnostic code numbers.
• To increase the selected diagnostic code number, press the "TCS" button. Press the "TCS" button for
1 second or more to automatically increase the diagnostic code numbers.
" 01 " " 83 "
" 83 " " 01 "
6. Shift the transmission into gear and extend the sidestand.
ECA1MC1027
NOTICE
If the " " side of the start/engine stop switch is pushed without performing step 6, the starter
motor gears or other parts may be damaged.
7. Check the operation of the sensor or actuator.
• Sensor operation
The data representing the operating conditions of the sensor appears on the multi-function meter
right display.
FUEL INJECTION SYSTEM
DIAG
DIAG
DIAG
DATA
8-37
01
15