Yamaha FJR1300A(D) Service Manual page 524

Fault code No.
Item
3 "02" is indicated in diagnostic
mode (code No. 60). EEP-
ROM data error for adjust-
ment of CO concentration of
cylinder #2.
4 "03" is indicated in diagnostic
mode (code No. 60). EEP-
ROM data error for adjust-
ment of CO concentration of
cylinder #3.
5 "04" is indicated in diagnostic
mode (code No. 60). EEP-
ROM data error for adjust-
ment of CO concentration of
cylinder #4.
6 "17" is indicated in diagnostic
mode (code No. 60). EE-
PROM data error for ISC
(idle speed control) learning
values.
44
EEPROM fault code number: an error is detected while reading
or writing on EEPROM.
Change the CO concentra-
tion of cylinder #2, and re-
write in EEPROM.
Refer to "ADJUSTING THE
EXHAUST GAS VOLUME"
on page 3-10.
After this adjustment is
made, the memory is not re-
covered when the main
switch is turned to "OFF". →
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-174.
Change the CO concentra-
tion of cylinder #3, and re-
write in EEPROM.
Refer to "ADJUSTING THE
EXHAUST GAS VOLUME"
on page 3-10.
After this adjustment is
made, the memory is not re-
covered when the main
switch is turned to "OFF". →
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-174.
Change the CO concentra-
tion of cylinder #4, and re-
write in EEPROM.
Refer to "ADJUSTING THE
EXHAUST GAS VOLUME"
on page 3-10.
After this adjustment is
made, the memory is not re-
covered when the main
switch is turned to "OFF". →
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-174.
Turn the main switch to
"OFF".
8-75
FUEL INJECTION SYSTEM
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Repeat item 1. If
the same number is indicat-
ed, go to item 7.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Repeat item 1. If
the same number is indicat-
ed, go to item 7.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Repeat item 1. If
the same number is indicat-
ed, go to item 7.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Repeat item 1. If
the same number is indicat-
ed, go to item 7.