b. Make sure that the grommet on the tail/brake
light assembly fits into the slot in the rear
cowling.
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
EAS1MC1051
REMOVING THE SIDE COVERS
The following procedure applies to both of the
side covers.
1. Remove:
• Side cover "1"
TIP
Pull the bottom of the side cover outward to re-
move it from the grommet on the frame.
EAS1MC1052
INSTALLING THE SIDE COVERS
The following procedure applies to both of the
side covers.
1. Install:
• Side cover "1"
TIP
Make sure that the grommet on the frame fits
into the slot in the side cover.
1
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
EAS1MC1055
INSTALLING THE SEATS
1. Install:
• Rider seat height position adjuster
• Rider seat
TIP
The rider seat height can be adjusted to one of
two positions to suit the rider's preference.
▼
▼▼▼
▼ ▼▼▼
▼
To install the rider seat in the high posi-
tion
a. Move the rider seat holder cover "1" to the
lower position as shown.
▲▲▲
b. Install the rider seat height position adjuster
"2" so that the "H" mark "a" is aligned with the
match mark "b".
1
c. Insert the projection "c" on the front of the rid-
er seat "3" into seat holder "d" as shown.
1
d. Align the projection "e" on the bottom of the
rider seat "3" with the "H" position slot "f", and
then push the rear of the seat down to lock it
in place as shown.
4-3
GENERAL CHASSIS
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
3
▼ ▼▼▼
▼
▼▼▼
1