Top Cover - Fuji Xerox Phaser 5500 Service Manual

Top Cover

Caution
Use care not to catch the the Stack Full sensor flag while removing the cover.
1.
Open the Front Door.
2.
Remove the Front Left Cover (page 8-5).
PL1.1.8
3.
Remove the two screws securing the Top Cover.
4. Remove the Top Rear Cover by first lifting the right edge while sliding the cover
to the right, then pulling the cover forward and left.
5.
Disconnect the Front Panel connector from the Top Cover.
Replacement Note
Make sure the spur and tab on the rear side of the cover engage the frame.
FRU Disassembly
Top Cover
Connector
s5500-078
8-7