Tray N Failure - H1 -1/2/3/4 Tray N Fail - Fuji Xerox Phaser 5500 Service Manual

Tray n Failure - H1 -1/2/3/4 Tray n Fail

Detected lift failure. Paper size detection inoperative.
Applicable Error Codes
Tray 2 Failure - H1-1 Tray 2 Fail
Tray 3 Failure - H1-2 Tray 3 Fail
Tray 4 Failure - H1-3 Tray 4 Fail
Tray 5 Failure - H1-4 Tray 5 Fail
Universal Tray Failure Troubleshooting Reference
Applicable Parts
Tray
Feeder
Feed/Lift Motor
Level Sensor
Paper Size Switch
Tray 4-5 PWB
Engine Logic
Board.
Universal Tray Failure Troubleshooting Procedure
Step Actions and Questions
1 Check paper supply.
Is paper loaded in the affected tray?
2 Check the tray.
Replace the tray with one from another
position.
Does the replaced tray lift?
3 Check lift components.
Is the Sector Gear or surrounding parts
damaged?
4
Test the Feed/Lift Motor.
Run the Service Diagnostics Lift Motor test
for the affected tray.
Does the motor operate properly?
Error Messages, Codes, and Procedures
References
Print Engine P/J Tray 2 & 3 Feeders (page 10-11)
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Tray 2 & 3 Wiring (page 10-26)
PL2.1 Tray (1/2) and Feeder (1/2) (page 9-8)
PL2.2 Tray (2/2) (page 9-10)
PL2.3 Feeder (2/2) (page 9-12)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
1000-Sheet Feeder P/J Locator (page 5-5)
1000-Sheet Feeder Tray 4 & 5 Wiring (page 5-9)
PL20.2 Tray 4-5 Tray (1/2) Feeder (1/2) (page 4-6)
PL20.3 Tray 4-5 Tray (2/2) (page 4-8)
PL20.4 Tray 4-5 Feeder (2/2) (page 4-10)
PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Yes
Go to Step 2.
Go to Step 3.
Replace the tray.
Go to Step 9.
No
Load paper and
go to Step 2.
Go to Step 4.
Go to Step 4.
Go to Step 5.
3-141