Printer Front Door Is Open - Front Cover Is Open - Fuji Xerox Phaser 5500 Service Manual

Punch Box Full (Punch Box Counter) Troubleshooting Procedure (Continued)
Step Actions and Questions
8
Check the Punch Box Set Sensor signal.
Does the voltage across P/J8307-A2 <=>
P/J8307-A3 on the Finisher Main PWB
change when the Punch Box is removed
or replaced?
9 Replace the Finisher Main PWB.
Does the error still occur?

Printer Front Door is Open - Front Cover is Open

The Printer's Front Door Interlock Switch indicates that the Front Door is open.
Front Door Open (Front Door Interlock) Troubleshooting Reference
Applicable Parts
Front Cover Interlock
Switch
Engine Logic Board.
Front Door Open (Front Door Interlock) Troubleshooting Procedure
Step Actions and Questions
1
Check Front Door operation.
Does the Front Door open and close
normally?
2 Test the Front Door Interlock Switch.
Run the Service Diagnostics Front Cover
Switch test.
Does the sensor status change when
the Front Door is opened and closed?
3 Check the switch connections.
Are P/J121 and P/J405 connected?
4 Check continuity between the switch and
the Engine Logic Board.
Is there continuity on each wire
between P/J121 <=> P/J405?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine P/J Locator LVPS (page 10-16)
Print Engine LVPS Wiring (page 10-21)
PL1.1 Covers (2/2) (page 9-6)
PL8.1 Print Engine Electrical (page 9-40)
Yes
Go to Step 9.
Replace the
Engine Logic
Board
(page 8-89).
Yes
Go to Step 2.
Replace the
Engine Logic
Board.
Go to Step 4.
Go to Step 5.
No
Replace the
Punch Box Set
Sensor
(page 3-154).
Problem solved.
No
Correct the
installation.
Go to Step 3.
Connect P/J121
and P/J405.
Repair the wiring.
3-235