Table of Contents
Advertisement
S
S
UPER
ERVER 6027AX-72RF/TRF-HFT1/HFT2/HFT3 User's Manual
SAS2
SAS1
SAS0
SATA2 (ISATA2)
SATA1 (ISATA1)
SATA0 (ISATA0)
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
Figure 6-1. Chassis: Front View
Control Panel
Hard Drive Bays (10)
6027AX-72RF Drive Confi guration
SAS5
SAS4
SAS7
SAS3
SAS6
6027AX-TRF Drive Confi guration
SATA5 (SSATA1)
SATA4 (SSATA0)
SAS7 (SSATA3)
SATA3 (ISATA3)
SAS6 (SSATA2)
6-2
LCD Screen
SATA1
SATA0
SATA10 (ISATA5)
SATA9 (ISATA4)
Advertisement
Table of Contents
