Accessing The Inside Of The System - Supermicro 6027AX-TRF-HFT2 User Manual

6-3

Accessing the Inside of the System

1. If rack mounted, fi rst, grasp the two handles on either side and pull the sys-
tem straight out until it locks (you will hear a "click").
2. Remove the two screws on each side of the cover, which secure the cover to
the chassis.
3. Press the release tabs to remove the cover from the locked position. Press
both tabs at the same time.
4. Once the top cover is released from the locked position, slide the cover
toward the rear of the chassis.
5. Lift the cover off the chassis.
6. To remove the system from the rack completely, press the locking tabs in the
chassis rails (push the right-side tab down and the left-side tab up) to con-
tinue to pull the system out past the locked position. See Figure 6-2
Figure 6-2. Accessing the Inside of the System
Chapter 6: Advanced Chassis Setup
1
2
Remove
Screw
1
3
1
3
6-3
1
5
1
4
1
2
Remove
Screw