Canon NP2120 Service Manual page 157

Note:
Keep the grounding wire as far as possible
from the DC harness.
Figure 5-25
9) Disconnect the shorting connector of the control
panel shown in Figure 5-26.
10) Connect the 4P connectorof Control Card V and
the 4-P connector of the control panel on the
copier side.
Figure 5-26
11) Mount the control panel on the copier; then,
arrange the grounding wire of Contra1 Card V
12) Remove the protection sheet from the control
panel guide plate of Control Card V.
13) Attach the control panel guide plate of Control
Card Von the control panel of the copier.
Figure 5-27
14) Turn the copier ON, and check the operation of
Control Card V.
15) Attach the inside right cover.
CANON NPZl20/2MD RN.1 JAN. 1592 PAINTED IN JAPAN IIMPAIME AU JAPONI