Canon NP2120 Service Manual page 154

1) Hold both ends so that the yellow seal (round) is
tothefront,andturnitinthedirectionofthearrow
about ten times as shown below.
Figure 5-16
2) Take the CT unit from the storage case, and set
it in the copier; thereafter, hold the CT unit in
place, and pull the yellow tab straight out.
Note:
Do not pull out the orange
Figure 5-17
film.
CANON NPZlZO/ZMO RN.0 MAY 1990 PAINTEil IN JAPAN IIMPRIME AU JAPORI
3) Put the CT unit back into Ihe sloraae case and
shake it about ten times in Ihe dlreclion of thc
arrow.
Figure 5-16
Shake it in the direction of the arrows about ten
times.
Figure 5-19
Set the CT unit in the copier once again, and
make test copies in the DIRECT mode; repeat
step 4) if the image is uneven.
Set the CT unit in thecopier, and pull the orange
tab out;
straight thereafter, close the front door.
Figure 5-20
5-l 3