Adjustment / Settings - Canon Selphy DS700 Service Manual

3-3. Adjustment / Settings

(1) Paper feed motor adjustment
Perform the following adjustments when the paper feed motor ass'y is replaced:
1) When attaching the motor, fasten the screws so that the belt is properly stretched (in the direction indicated by the blue arrow
in the figure below).
2) After replacement, be sure to perform the service test print, and confirm that no strange noise or faulty print operation (due to
dislocation of the belt or gear, or out-of-phase motor, etc.) occurs.
Note: The red screws securing the paper feed motor may be loosened only at replacement of the paper feed motor ass'y. DO
NOT loosen them in other cases.
(2) Access cover gear phase adjustment
After replacement or re-assembly of the access cover unit (QM2-1982) or main cover unit (QM2-1955), adjust the gear phase.
If the main cover unit is replaced with a new unit, apply grease to the locations specified in (4), Grease application, below.
1) Inside the main cover unit, confirm that the access cover spring end fits in the groove of the main cover.
2) Rotate the gear in the direction indicated by the blue arrow, and hold it so that the boss position matches the recess of the
access cover arm sliding portion.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
1 - 22