List Of Error Display / Indications; Operator Call Errors; Service Call Errors - Canon Selphy DS700 Service Manual

2. LIST OF ERROR DISPLAY / INDICATIONS

Errors and warnings are displayed by the following ways:
1) Errors are indicated by the number of times the LED blinks.
2) Errors and warnings are displayed on the TV.
3) Errors and warnings are displayed on the printer driver's Status Monitor.

2-1. Operator Call Errors

(by LED Blinking in Orange)
LED
blinking
Error [Error code]
in orange
No paper. (ASF) [1000]
2 times
Paper jam. [1300]
3 times
4 times
No ink tank. [1662]
5 times - The print head is not
installed, or it is not
properly installed. [1401]
- EEPROM data of the print
head is faulty. [1403 /
1405].
8 times Warning: The waste ink
absorber is almost full
(approx. 95% of the
maximum capacity). [1700]
9 times The connected digital camera
or digital video camera does
not support Camera Direct
Printing. [2001]
Access cover open. [1200]

2-2. Service Call Errors

(by LED Blinking in Orange and Green Alternately, or Lit in Orange)
LED alternate
blinking in orange
and green
2 times Carriage error [5100]
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Set the paper in the ASF, and press the
Resume/Cancel button.
Remove the jammed paper, and press the
Resume/Cancel button.
Install an ink tank, and press the
Resume/Cancel button.
- Install the print head properly, and close
the access cover, or, with the print head
installed, turn the printer off and on.
- If the error is still not resolved, the print
head may be defective. Replace the print
head.
Pressing the Resume/Cancel button will
exit the error, and enable printing.
In repair servicing, replace the ink
absorbers.
After removing the cable between the
camera and the printer, press the
Resume/Cancel button, and re-connect the
cable. If the error is still not resolved, a
non-supported camera may be connected.
Connect a supported camera.
Close the access cover.
Error [Error code]
Solution
(Replacement of listed parts, which are likely to be faulty)
- Carriage unit (QM2-1974)
- Timing slit strip film (QC1-5153)
- Logic board ass'y (QM2-1961)
- Carriage motor ass'y (QM2-1744)
1 - 4
Remarks
The service call error, indicating the
waste ink absorber is full, is likely to
occur soon.
Solution
*1