Warnings - Canon Selphy DS700 Service Manual

3 times Paper feed error [6000]
4 times Purge unit error [5C00]
5 times ASF cam sensor error [5700]
6 times Internal temperature error [5400]
7 times Waste ink absorber full [5B00]
8 times Print head temperature rise error
[5200]
9 times EEPROM error [6800]
Continuous ROM error
alternate blinking
Lights in orange RAM error
*1: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROM information
print). If the waste ink amount is 7% or more, also replace the ink absorbers (QC1-5195 / 5196 / 5566 / 5567 / 5568 ) when
replacing the logic board ass'y.
[See Section 3-3. Adjustment / Settings, (7) Service mode, for details.]

2-3. Warnings

Printer (displayed via the Status Monitor or on the TV, no LED indication):
Displayed warning
Ink low warning 1 (approx. half level)
Ink low warning 2 (low remaining ink, display of "!" in the
warning)
Ink low warning 3 (ink level unknown, display of "?" in the
warning)
Print head temperature rise
Protection against excess rise of the print head temperature
*1: If the warning is displayed, the carriage does not move to the ink tank replacement position when the access cover is
opened.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
- Timing sensor unit (QM2-1759)
- Timing slit disk ass'y (QL2-0843)
- Paper feed motor ass'y (QM2-1746)
- Feed roller ass'y (QM2-1970)
- Platen (QC1-5176/5177)
- Logic board ass'y (QM2-1961)
- Purge unit (QM2-1975)
- Logic board ass'y (QM2-1961)
- Sheet feed unit (QM2-1964)
- Logic board ass'y (QM2-1961)
- Ink absorber (QC1-5195 / 5196 / 5566 / 5567 / 5568)
- After replacement of the ink absorber, reset the EEPROM
(waste ink amount value) on the logic board ass'y.
- Print head (QY6-0056)
- Logic board ass'y (QM2-1961)
- Logic board ass'y (QM2-1961)
- Logic board ass'y (QM2-1961)
- Logic board ass'y (QM2-1961)
The warning is displayed only when printer driver's Low Ink
Warning Setting is enabled.
The warning is displayed only when printer driver's Low Ink
Warning Setting is enabled.
The warning is displayed only when printer driver's Low Ink
Warning Setting is enabled.
If the print head temperature is high when the access cover is
opened, the warning is displayed.
When the print head temperature falls below the specified
temperature, the warning is released.
If the print head temperature exceeds the specified limit, a
Wait is inserted during printing,
When the print head temperature falls below the specified
temperature, the warning is released.
1 - 5
*1
*1
*1
*1
*1
*1
*1
Remarks
*1