Canon Selphy DS700 Service Manual page 13

Graphic or text is enlarged on printouts.
*1: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROM information
print). If the waste ink amount is 7% or more, also replace the ink absorbers (QC1-5195 / 5196 / 5566 / 5567 / 5568 ) when
replacing the logic board ass'y.
[See Section 3-3. Adjustment / Settings, (7) Service mode, for details.]
*2: Replace the print head only after the print head deep cleaning is performed 2 times, and when the problem persists.
*3: To perform bottom plate cleaning, with the printer power turned on, press and hold the Resume/Cancel button until the
Power lamp blinks 5 times, then release the button. For details,
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
<Part 1: 2. LIST OF ERROR DISPLAY / INDICATION>
see Section 3-3. Adjustment / Settings, (6) User mode.
1 - 7
- ink tank, or
*2
- print head .
When enlarged in the carriage
movement direction, clean
grease or oil off the timing slit
strip film, or replace the
- timing slit strip film,
- carriage unit, or
*1
- logic board ass'y .
When enlarged in the paper
feed direction, clean grease or
oil off the timing slit disk ass'y,
or replace the
- timing slit disk ass'y,
- timing sensor unit, or
*1
- logic board ass'y .
To the top