Installation; Installation Overview - Extron electronics HDMI DA4 User Manual

Installation

This section of the guide describes the following topics concerned with the installation and
setup of the HDMI DA4 and HDMI DA6 distribution amplifiers.
z
z
z
z
z
z
z

Installation Overview

To install and set up the HDMI DA4 or HDMI DA6, follow these instructions:
1.
2.
3.
4.
5.
Installation Overview
Rear Panel Features
Connecting Power
Connecting the Input Source
Connecting Output Displays
Wiring for RS-232 Control
Connecting to the USB Port
Mount the Distribution Amplifier
Connect to a 100-240 VAC (50 or 60 Hz) power source
cord (see page 4).
Connect the display devices
The distribution amplifier automatically reads and stores EDID from the selected display
device. By default, this is the device connected to output 1. For other EDID options, see
EDID Minder
on page 11.
If configuration using SIS commands
to the rear panel captive screw connector
(see page 7).
Connect and power on the input device
in a suitable location (see page 14).
using the provided IEC power
and power them on (see page 5).
is required (see page 15), connect a control PC
(see page 6) or the
(see page 5).
HDMI DA4 and HDMI DA6 • Installation
front panel USB port
3