Remove/Replace Card Path/Cover Sensor (D930613) - Fargo C50 Service Manual

3.13

Remove/Replace Card Path/Cover Sensor (D930613)

Step Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the
Printer.
2 Remove the mainboard.
Remove the J11 and J17 connector from the mainboard.
3 Use a small flathead screwdriver to GENTLY pry the sensor up.
The sensor must be released from the small tab holding the sensor.
( See the RED arrow)
(The cable is shown on THIS side of the frame for clarity.)
August 2013
HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary information,
which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written consent of HID Global
Corporation. If you are an unintended recipient of this information or are unwilling to accept the above restrictions, please immediately return
this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106..
C50 Card Printer Service Manual PLT-01278 rev 1.1
Tools needed: T10 Torx screwdriver
Estimated Repair Time: 30 min
Preparation: Remove the Covers
Important: This procedure can only be performed by
authorized service personnel.
Page 46