Fargo C50 Service Manual page 12

3 Remove the 2 screws (F000178) shown. The center open hole is for the frame peg.
4
Slide board out
5 Install new board and reconnect all wires.
Wires are labeled for location connection.
6 Procedure is complete.
August 2013
HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary information,
which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written consent of HID Global
Corporation. If you are an unintended recipient of this information or are unwilling to accept the above restrictions, please immediately return
this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106..
from the slots on the front sideplate.
C50 Card Printer Service Manual PLT-01278 rev 1.1
Page 12