Procedure 4 Diagnostic Test Program Execution Check - Toshiba T3300SL Maintenance Manual

If you cannot format the HDD using the Diagnostic Program, go to Procedure 4.
Procedure 4 Diagnostic Test Program Execution Check
The HDD test program is stored in the T3300SL Diagnostic Disk. Perform all of the HDD tests in
the Hard Disk Drive Test. Refer to Chapter 3, Tests and Diagnostics, for more information about
the HDD test program.
If an error is detected during the HDD test, an error code and status will be displayed; perform
Check 1. The error codes and statuses are described in Table 2-4. If an error code is not generated,
the HDD is operating properly.
Check 1 Replace the HDD unit with a new one following the instructions in Chapter 4, Re-
placement Procedures. If the HDD is still not functioning properly, perform Check 2.
2-26
Code
01h Bad command
Table 2-4 Hard disk drive error codes and statuses
02h Bad address mark
04h Record not found
05h HDC not reset
07h Drive not initialize
09h DMA boundary error
0Ah Bad sector error
0Bh Bad track error
10h ECC error
11h ECC recover enable
20h HDC error
40h Seek error
80h Time out error
AAh Drive not ready
BBh Undefined
CCh Write fault
E0h Status error
F0h Not sense error (HW. code = FF)
Status