Installing The Back Cover, Lcd Module, Fl Inverter Board, & Display Mask - Toshiba T3300SL Maintenance Manual

10. To remove the back cover, pull the display cable positioned along the bottom edge of the
back cover away from the cover. Release the mylar tab from the right display hinge
(Figure 4-38).
11. Remove the one M2.5x6 screw and the two M2x4 screws from the display support hinges
(Figure 4-38).
M2.5x6 screw
Figure 4-38 Removing the back cover of the LCD module
CAUTION: Be careful removing the back cover! It may be necessary to rotate the cover
slightly so that you do not damage the bottom portion of the cover over the hinges.
4.11.2 Installing the Back Cover, LCD Module, FL Inverter Board, and Display Mask
1. Position the back cover, making sure that the mylar tab is not pinched between the right
display hinge and the cover (Figure 4-38). Secure the mylar tab between the two screw
holes.
CAUTION: Before firmly securing the back cover screws, make sure the display cables are
not pinched by the hinges or the screws securing the back cover.
2. Secure the back cover with the two M2x4 screws and one M2.5x6 screw (Figure 4-38).
4-38
Figure 4-37 Disconnecting the LCD display cables
Back cover
M2x4 screws