4.1.4 Tools and Equipment
The use of ElectroStatic Discharge (ESD) equipment is very important to your safety and the safety
of those around you. Proper use of ESD devices will increase the success rate of your repairs and
lower the cost of damaged or destroyed parts and FRUs. The following equipment is necessary to
disassemble and reassemble the T3300SL:
One 2mm Phillips-head screwdriver to remove and replace screws
One 3mm Phillips-head screwdriver to remove and replace the ground screw
Tweezers to lift out screws that you cannot grasp with your fingers
One System Board Support Block (85mm x 120mm x 300mm/3¼"h x 4¾"d x 12"w)
This block must be composed of anti-static foam.
One LCD Support Block (30mm x 200mm x 300mm/1¼"h x 8"d x 12"w)
This block must be composed of anti-static foam.
ESD mats for the floor and table you are working on
ESD wrist strap or heel grounder
Anti-static carpeting and flooring
Air ionizers in highly static sensitive areas
4-8