Toshiba T3300SL Maintenance Manual page 146

5. Eleven plastic latches secure the display mask to the back cover of the LCD module. To
release these latches, start with the top three latches first and work your way around the
mask until all eleven latches are released. Gently separate the display mask from the back
cover (Figure 4-34).
Figure 4-34 Releasing the eleven latches on the display mask
CAUTION: Before removing the display mask from the T3300SL, make sure the display
panel is opened to an angle of more than 90° to prevent breakage of the display hinge
supports on the mask (Figure 4-34).
6. To remove the FL inverter board, remove the two M2x6 screws at the top and bottom of
the FL inverter board. Release the mylar shielding attached to the bottom of the mylar
shielding that covers the FL inverter board (Figure 4-35).
7. Gently rotate the FL inverter board toward the LCD display to expose the three cables
connecting the FL inverter board to the LCD display. Disconnect the cables from CN1,
CN2, and CN3 to remove the FL inverter board from the T3300SL (Figure 4-35).
4-36
Figure 4-35 Removing the FL inverter board