D-Link DSR-150 User Manual page 83

Section 5 - Connect to the Internet
Field
OSPFv3 Enable
Interface
Priority
Hello Interval
Dead Interval
Cost
Save
D-Link DSR-Series User Manual
Toggle ON to enable OSPFv3.
Displays the physical network interface on which OSPFv3 is Enabled/Disabled.
Helps to determine the OSPFv3 designated router for a network. The router with the highest priority
will be more eligible to become Designated Router. Setting the value to 0 makes the router ineligible to
become Designated Router. The default value is 1. Lower the value means higher the priority.
The number of seconds for Hello Interval timer value. Enter the number in seconds that the Hello packet
will be sent. This value must be the same for all routers attached to a common network. The default
value is 10 seconds.
The number of seconds that a device's hello packets must not have been seen before its neighbors
declare the OSPF router down. This value must be the same for all routers attached to a common
network. The default value is 40 seconds. OSPF requires these intervals to be exactly the same between
two neighbors. If any of these intervals are different, these routers will not become neighbors on a
particular segment.
Enter the cost of sending a packet on an OSPFv3 interface.
Click Save to save your settings.
Description
70